If you’re building a 3rd gen 4Runner, chances are the Bilstein 5100s are already on your list.
The Bilstein 5100 Ride Height Adjustable Front Shock is one of the most proven suspension upgrades for the 1996–2002 Toyota 4Runner. Whether you’re trying to level the front end, clear larger tires, improve ride quality, or build a capable overland setup, these shocks are one of the best bang-for-your-buck suspension mods you can install.
This listing is for a single front shock absorber. You must add quantity 2 to cart for a complete front suspension setup.
Built around Bilstein’s monotube technology, the 5100 delivers better control, reduced fade, and improved handling both on-road and off-road compared to worn factory suspension.
The adjustable snap-ring grooves allow you to reuse your factory coil springs while dialing in front lift height from approximately 0–2.3 inches depending on vehicle setup and spring condition.
Whether your 3rd gen spends its life commuting, exploring forest roads, or crawling through Moab, the 5100s are one of the most trusted suspension upgrades in the Toyota world.
If shipping outside of the lower 48, please contact us before ordering. Additional shipping charges will be invoiced after checkout.
Why 3rd Gen 4Runner Owners Run Bilstein 5100s
- Eliminates worn-out factory ride feel
- Adjustable front lift without spacers
- Clears larger tires easier
- Improves ride quality and stability
- Excellent daily driving and trail balance
- Proven reliability in the Toyota off-road world
Key Features
- Adjustable ride height front shock
- Designed specifically for lifted trucks and SUVs
- Monotube gas pressure technology
- Snap-ring grooves for multiple lift settings
- Reuses factory front coil springs
- Direct bolt-on installation
- Fade-free performance on and off-road
- Zinc-plated corrosion-resistant finish
- Made in the USA
- Lifetime warranty through Bilstein
Lift Height Information
Depending on vehicle trim and spring condition, these shocks can provide approximately:
- 0" lift
- .85" lift
- 1.75" lift
- Up to approximately 2.3" front lift
Vehicle Fitment
Fits:
- 1996–2002 Toyota 4Runner SR5
- 1996–2002 Toyota 4Runner Limited
- 1996–2002 Toyota 4Runner Base
Compatible with many 0–2” lift setups.
4WD applications supported.
Important Notes
- Sold individually
- Add quantity 2 for complete front pair
- Factory coil springs reused
- Alignment required after installation
- Professional installation recommended if unfamiliar with coilover assembly
- Position:
- Front
- Sold As:
- Single
- Lift Range:
- 0–2.3" Front Lift
- Adjustable Height:
- Yes
- Shock Type:
- Monotube
- Reservoir:
- No
- Body Diameter:
- 46mm
- Finish:
- Zinc Plated
- Installation Type:
- Bolt-On
- Factory Springs Reused:
- Yes
- Best Use Case:
- Daily driving, overlanding, trail use
- Made In:
- USA
- Warranty:
- Lifetime
